CONTACLIP TTPCard Kullanıcı Kılavuzu - Sayfa 7

Yazıcı CONTACLIP TTPCard için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. CONTACLIP TTPCard 11 sayfaları. Thermal transfer printer

4.7

Load media sheets for printing

A sheet of media comprises a number of identical moulded or die-cut blanks. Available in a variety of

sizes, materials and colours to suit all applications, the range of media is shown in the CONTA-CLIP

TTPCard catalogue.

4.7.1

Position media sheets on the CCI-PC/PVC/PVCF support template

All die-cut sheets of flat media are printed on the CCI-PC/PVC/PVCF template and have two holes to

locate on pins mounted on the template:

•

Press the green button (4) to open the carriage already fitted with the template (See section

4.6).

•

Position the sheet by hand, fitting its holes fully over the corresponding locating pins on the

template; the side to be printed must face upwards (See FIG. B and C).

•

Once loaded, the sheet must be fl at, square, clean and without protrusions, bends or kinks;

this allows correct positioning of the print head during the printing cycle.

4.7.2

Position media sheets on the CCI-PC-TPM, CCI-PC-TDM, CCI-PC-CPM/SPM, CCI-PC-

CPM-09, CCI-PC-CPM-05/12, CCI-PC-CPM-06, CCI-PC-CPM-10, CCI-PC-CPM-01, CCI-PC-CPM-13

templates

To position the card for cable marking or cards for terminals marking the following must be

observed:

•

Press the green button (4) to open the carriage already equipped with the template (See

section 4.6).

•

Position the sheet by hand such that the open 'first' row of tags/markers is nearest to TTPCard

with the locating lugs on the underside of the sheet inserted fully into the corresponding holes

in the template (See FIGS. B and C). Once loaded, the sheet must be flat, square, clean and

without protrusions, lifted or bent components; this allows correct positioning of the print head

during the printing cycle.