CONTACLIP TTPCard Kullanıcı Kılavuzu - Sayfa 8

Yazıcı CONTACLIP TTPCard için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. CONTACLIP TTPCard 11 sayfaları. Thermal transfer printer

4.8

Printing cycle

•

Ensure there is a genuine printable medium correctly positioned on the template then:

Set the data in the program, proceed via Print Setup to Print Preview (Consult user manual)

then press F6 to start the printing cycle; the carriage will close then gradually open again

automatically, until it stops fully open at the end of the cycle, with the sheet printed.

•

Remove printed sheet and continue loading/print preview/printing cycle.

For the best printing results, we recommend:

•

Using only genuine CONTA-CLIP materials (media, printer ribbons, spares and cleaning kits).

•

Handling blank media sheets carefully to avoid touching the print surface with the fingers.

•

Before printing, always check the cleanliness of the sheets. If necessary wipe the surface with

a soft cloth.

•

Keeping new or partially used sheets clean and dry, eg in their original packaging.

•

When printing partially used sheets, ensure there are no protruding sprues, burrs along the

sheared edges or tags bent upwards which may damage the print head.

•

When printing partially used sheets, ensure the Jump function is used correctly to avoid

printing non-existent media, contaminating the support template and possibly causing

irrevocable damage to the print head.

5.0

Maintenance

5.1

Clean the print head (recommended at each ribbon replacement)

Using only a genuine TTPCard CLEANING KIT (28043.0), proceed as follows:

•

Switch the TTPCard OFF.

•

Switch the TTPCard ON and press the green button (4) for less than 6 seconds until the

yellow LED (2) starts blinking.

•

Release the green button. The yellow and orange LEDs blink while the green LED remains lit

and the carriage (5) remains open. The TTPCard is then in 'Cleaning mode'.

Open 'first' row of tags/

markers should be nearest

Open 'first' row of tags/

markers should be nearest

to the TTPCard