3xLogic infinias eIDC32 Hızlı Başlangıç Kılavuzu - Sayfa 8

Ağ Geçidi 3xLogic infinias eIDC32 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. 3xLogic infinias eIDC32 17 sayfaları.

and DC power are connected to the Power Injector, priority is given

to the DC power supply. In such instances, PoE power is still being

allocated by the PoE switch and counts toward the aggregate total

power budget of the switch. For additional information about

power restraints, refer to the

And

Reference" manual.

3. Run another standard network cable (Cat 5 or Cat 6) from the

Power Injector to the eIDC Ethernet connector.

4. Go to "Determine the eIDC IP Address" below and complete the

installation.

DETERMINE THE eIDC IP ADDRESS

Once attached, the eIDC appears as a full IP client on the data network

and requires an IP address. The eIDC network connection is either for

static addressing or Dynamic Host Configuration Protocol (DHCP)

addressing. Use of a DHCP permanently leased IP address or a static IP

address is required by the eIDC.

When power is initially applied to the eIDC, the eIDC sends a signal to

the current IP address. A signal is also sent when the eIDC is rebooted.

To determine the type of IP address:

1. Connect power to the eIDC.

2. Use the numbered LEDs, located on the upper-left and upper-right

sides of the eIDC module, to note the IP address: left side,1 to 5;

right side, 6 to 0.

3. Disconnect the power from the eIDC, and then reconnect the

power. The eIDC unit starts and attempts to acquire an IP address.

(This occurs because the eIDC is shipped from the factory set for

DHCP addressing).

"infinias Hardware Installation

QSG-002 / 01-03-2017