Belimo FS Series Talimatlar Kılavuzu - Sayfa 16

Motor Belimo FS Series için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Belimo FS Series 20 sayfaları. Replacement of multiproducts motors
Ayrıca Belimo FS Series için: Değiştirme (19 sayfalar), Talimat Sayfası (18 sayfalar)

Sayfayı Yazdır
Belimo FS Series Talimatlar Kılavuzu

Miscellaneous parts

Should they be needed, Belimo carries a range of parts. Ball joints and 5/16"
rods are available from most distributors.
KH8
KG8 3/8"
KG6, KG10A ¼"
SH8 (not shown – see picture page 9). Push-rod for KG6 & KG8 ball joints. 5/16" 36" long
Use SH10 3/8" rods for GMB and dual FSAF or FSNF linkages. 5/16" can bend under heavy
loads.
Thermal sensor replacements – BAE165 US
Where existing sensor is defective or one must be added, the 165°F primary
sensor may be used. Original equipment is recommended although not
strictly required by code. UL does not regulate replacement or repair. See
NFPA 80 or NFPA 105.
Greenheck MP2985 & MP2986 Motors with Belimo FSxx Series
Where the crank arm on the jackshaft is broken or
not of the type needed, the KH12 fits over the
shaft without removing it. Zinc plated steel. Slot is
for the KG10A ball joint. V-bolt fits ¾" to 1" (20 to
25mm) shafts.
KH-6. Zinc plated steel. For shafts 3/8" to 11/16"
Uses KG6 ball joint. Slot width 1/4"
KH-8. Zinc plated steel. For shafts 3/8" to 11/16"
Uses KG8 (90 degree) or KG10A ball joint. Slot
width 21/64"
Damper blade clip and ball joints for blades
typically 3.5" in width. Typically the actuator
or rod to shaft is in front of blade.
ZG-DC1
Damper blade clip and ball joints – typically
used for 6" wide blade control dampers.
ZG-DC2
Typically the ctuator or rod to shaft is above
or below the damper.
Belimo BAE165 US
January 2015
16