Abus PLBW10100 Manuel - Sayfa 14
Güvenlik Sensörleri Abus PLBW10100 için çevrimiçi göz atın veya pdf Manuel indirin. Abus PLBW10100 18 sayfaları. Nexello motion detector
Ayrıca Abus PLBW10100 için: Hızlı Kılavuz (2 sayfalar)
Sayfayı Yazdır
3. Advanced Z-Wave Parameters
3.1. Association Groups
Z-Wave devices can control other devices directly. This direct control is called association in Z-Wave.
The device ID of the device to be controlled must be stored in the controlling devices. This is done in
so-called association groups. An association group is always linked to an event in the controlling device
(keystroke or triggering of a sensor). When this event occurs, a control command - usually a BASIC
SET - is sent to all devices stored in an association group.
The device supports two association groups:
Group-
Maximum
Number
Devices
Group 1
5
Group 2
5
Group 1 (Association Z-Wave Controller)
The Lifeline Association is automatically established between the Z-Wave controller and the
device during inclusion and defines what information is exchanged between the Z-Wave
controller and the device.
Group 2 (direct association to terminals)
When the motion alarm is triggered, it sends a BASIC SET On / Off command to the nodes of
group 2
3.2. WakeUp Time
The time between the WakeUp Notification Commands can be set in the Wakeup Command Class
within the following values:
Minimum wake-up interval
Maximum wake-up interval
Default value Wake-up interval
Interval steps
Group name
Lifeline
on/off control
Description
Profile
General
Device Reset Locally Notification
Sensor Multilevel Report
Notification
14
English
command class
notification report
battery report
basic set
Value
20s
86400s (1 day)
21600s (6 hours)
20s