4B Binswitch BS1V6FC Kullanım Kılavuzu - Sayfa 9

Anahtar 4B Binswitch BS1V6FC için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. 4B Binswitch BS1V6FC 12 sayfaları. Capacitance point level switch

Sayfayı Yazdır

1. Check that the unit is correctly installed (see standard wiring diagram).

2. After going through the sensor calibration steps, the red LED should be "ON".

3. Introduce material to the Binswitch. If calibrated correctly, the Binswitch will activate when material

has been detected. Machinery shut down will depend on your specific monitoring setup. 4B

recommends an instant shutdown when maximum fill level or a plug condition has been detected.

If the system does not immediately shutdown as expected or alarm as required, then remove the

machine from service until the problem has been diagnosed and corrected.

FAULT

Unexpected Operation

False / Inconsistent Readings

Sensor Not Detecting Material

TESTING AND COMMISSIONING

WARNING

TROUBLESHOOTING GUIDE

Re-calibrate sensor, if problem continues contact 4B.

1. Check that sensor is not in the direct flow of material, and

remove from flow if necessary.

2. If sensor is coated in dust, re-calibrate by following calibration

Instructions.

1. If monitoring different types of materials, calibrate the sensor

Sensitivity to the lightest material being monitored.

2. Re-calibrate sensor, if problem continues contact 4B.

REMEDY

PAGE 9