APLOS ANGEL 600 GPD Kullanım Kılavuzu - Sayfa 5

Su Sistemi APLOS ANGEL 600 GPD için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. APLOS ANGEL 600 GPD 9 sayfaları. Direct flow reverse osmosis drinking water system

Sayfayı Yazdır
Display signal description
1. Filter life indicators
Filter life power indicators (red, yellow, green) display in real time and their color
reflects the corresponding filter lifespan.
1.1 Green indicates that the life of the filter is normal.
1.2 Yellow indicates that the life of the filter is about
to expire.
1.3 Red indicates that the filter life has expired and
needs to be replaced urgently. The system will
beep 5 times every 3 hours, until filter is replaced
and reset.
2. Flush button:
Press "Flush" to turn the rinsing function on and of f.
3. Reset button:
3.1. Press "Reset" to enter the reset mode: the RO
filter life indicator stays on and the other goes of f , indicating that the RO filter is
selected. Press "Reset" again to switch to the CFIII filter life indicator.
3.2 If there is no operation within 5 seconds, it will exit the "Reset" mode and return
to the regular operating state.
3.3 Hold "Reset" for 3 seconds to reset the life of the selected filter to its original life.
After reset, it will enter the regular operating state, and the filter life indicator will
turn green.

Filter Replacement

1. Shut off water supply to unit.
2. Open tap to drain pure water and release pressure. Close tap.
3. Isolate power and unplug unit.
4. Slightly bend the unit backward. Hold the bottom of the filter that is being replaced
and pull it out.The filter will rotate and come off.
5. Align the new filter with the corresponding tube inside the unit.
Press down firmly on the bottom of the filter until you hear a "click" sound,
indicating that it is properly installed.
6. Reactivate water supply and power
7. Check for any water leakage
8. Reset replaced filter lifespan (refer to the procedure described above, steps
3.1-3.3)
9. Press "Flush" button to flush the system`s filters
04