APLOS ANGEL 600 GPD Kullanım Kılavuzu - Sayfa 6

Su Sistemi APLOS ANGEL 600 GPD için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. APLOS ANGEL 600 GPD 9 sayfaları. Direct flow reverse osmosis drinking water system

Sayfayı Yazdır

Installation Step

Before installation, please check that all components are included in the package.

Figure 1

Figure 2

Figure 3

Figure 4

I. Install the three-way ball valve (see Figure 1)

1.1 Take out the three-way ball valve from the

accessory box.

1.2 Close the water inlet valve.

1.3 Connect the water inlet three-way valve and the

ball valve (note that the threaded connection

should be sealed with padding material and

seal ring).

1.4 Reconnect the original water pipe.

1.5 Connect the PE pipe to the water outlet of the

three-way ball valve and reserve a certain

length of the PE pipe.

II. Install the tap (see Figure 2)

2.1 Conﬁrm the installation location for the RO

tap and drill a hole.

2.2 Fix the tap in the installation position. Ensure

that the tap base does not rotate, the platform

and the water pipe connections do not leak.

2.3Connect the quick ﬁtting with a PE pipe ﬁrst,

then connect the other end of the quick ﬁtting

to the tap, leaving suf ﬁcient length for the

pipe .

III. Install the drain saddle (see Figure 3)

3.1 Install the drain saddle on the vertical drainpipe,

which is the recommended location.

3.2 Place the saddle on the drainpipe and align for

drilling.

3.3 Drill a hole in the drainpipe carefully. Be sure

not to penetrate the opposite side of the pipe.

Slip the front plate on one end of the tubing and

insert the tubing into the drilled hole for about

0.6''. Position the back plate on the drain pipe

by tightening the screws and nuts evenly while

leaving the tubing in the hole

IV. Connect pipes and power supply

4.1 Connect the pipe from the three-way ball valve

to the inlet water port and the pipe should be

connected securely to avoid leakage.

4.2 Connect the PE pipes from the tap to the RO

puriﬁed water and ﬁltered water ports

4.3 Connect the drain water pipe to the drain port.

Do not install any valve on the drain water pipe.

4.4 Activate power supply. First, connect the power

adapter to the unit power port, and then plug it

into the socket

V. Start up and Inspection

5.1 Open the RO tap and the water inlet ball valve.

RO system will start working, automatically

ﬂushing, and water will be discharged from the

drain pipe. After approximately 10 seconds, the

ﬂushing will end, and the RO system ill be ready

to purify water. Water will ﬂow through the ﬁlters

directly to the tap.

5.2 Stop the unit for inspection. Turn of f the tap.

The drain pipe will stop draining water, but the

system will continue operating until it is full of

puriﬁed water.

5.3 Pipeline inspection. During the trial operation,

check the parts, components, and connections

for leakage and looseness.

5.4 After installation and inspection drain water

from the RO tap for at least 10 min. Repeat at

least 3 times over the next 24 hours.