APlusLift HW-10KBP Kurulum ve Kullanım Kılavuzu - Sayfa 11
Kaldırma kolonları APlusLift HW-10KBP için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. APlusLift HW-10KBP 20 sayfaları. 2-post floor plate car lift 10,000lb capacity
Ayrıca APlusLift HW-10KBP için: Kurulum Kılavuzu ve Çalıştırma Talimatları (16 sayfalar), Kurulum ve Kullanım Kılavuzu (20 sayfalar)
Sayfayı Yazdır
Step 5 (Installing Swing Arms)
Locate the 4 swing arms and swing arm pins. Take one of the arms and insert it over
the hole in the carriage torsion tube. Line up the holes and insert the pin. Repeat for
the three other arms.
Step 6 (Electrical Connection to Power Unit)
the wiring must comply with local code. Find a certified
Warning:
electrician to connect the power unit to a power outlet. Protect each circuit
with a time delay fuse or circuit breaker.
The car lift uses a 220V single phase power unit. The running amperage is 10A.
Recommend a 30A breaker and a 10-gauge wire.
Yellow/Green is ground wire.
For 220V single split phase with two hot wires, wire blue to Hot 1 and wire brown to
Hot 2.
For 220V power from one hot and one neutral, wire blue to neutral and brown to hot.
See the figure below for the reference.
11