APlusLift HW-10KBP Handbuch für Installation und Betrieb - Seite 11
Blättern Sie online oder laden Sie pdf Handbuch für Installation und Betrieb für Hubsäulen APlusLift HW-10KBP herunter. APlusLift HW-10KBP 20 Seiten. 2-post floor plate car lift 10,000lb capacity
Auch für APlusLift HW-10KBP: Installationshandbuch & Betriebsanleitung (16 seiten), Handbuch für Installation und Betrieb (20 seiten)
Seite drucken
Step 5 (Installing Swing Arms)
Locate the 4 swing arms and swing arm pins. Take one of the arms and insert it over
the hole in the carriage torsion tube. Line up the holes and insert the pin. Repeat for
the three other arms.
Step 6 (Electrical Connection to Power Unit)
the wiring must comply with local code. Find a certified
Warning:
electrician to connect the power unit to a power outlet. Protect each circuit
with a time delay fuse or circuit breaker.
The car lift uses a 220V single phase power unit. The running amperage is 10A.
Recommend a 30A breaker and a 10-gauge wire.
Yellow/Green is ground wire.
For 220V single split phase with two hot wires, wire blue to Hot 1 and wire brown to
Hot 2.
For 220V power from one hot and one neutral, wire blue to neutral and brown to hot.
See the figure below for the reference.
11