Apogee V-2 Conversion Kit Talimatlar - Sayfa 3

Oyuncak Apogee V-2 Conversion Kit için çevrimiçi göz atın veya pdf Talimatlar indirin. Apogee V-2 Conversion Kit 5 sayfaları. Converts the spacemonkey models v-2/a4 plastic model kit into a flying model rocket

Sayfayı Yazdır

insert the motor mount tube into the aft end

of the body tube SO THE BACK RING IS

RECESSED AT LEAST ¼ INCH (6.5mm)

INSIDE THE END OF THE TUBE. Also,

the engine hook should NOT be in line with

the line on the tube. When the glue is dry,

pass the shock cord back through the motor

mount, so that it comes out the front end of

the rocket.

Step 6 - Take the red tube coupler and

place it on the plastic "aft nozzle insert" from

the Spacemonkey Models V-2 kit. Do not

glue it. Make sure it is straight on the nozzle

insert. Draw a line on the plastic with a pen-

cil, and remove the coupler tube.

Step 7 - Using a razor saw, cut the top

off the nozzle insert using the pencil line as

a guide. Clean up the edge with sandpaper.

The domed portion can be discarded.

Step 8 - Mark the middle of the aft edge

of the nozzle insert on the recessed portion

as shown. Anywhere around the ring is fine,

but this will now be the centerline of the fin.

Step 9 - Test fit the nozzle insert into the

back of the body tube from Step 5. The line

you made in Step 8 should align with the

pre-marked line on the outside of the body

tube. Also make sure the tube is straight on

the nozzle insert, and then glue it into place

using thick super glue.

Step 10 - Locate the laser-cut cardstock

centering ring. The side with the line etched

on it is the front side. Slide the ring over

the body tube and onto the front end of the

tube. The line on the ring should be aligned

with the lengthwise etched line of the tube,

and the front edge of the ring should be just

behind the perimeter line. Do not glue it yet.

Step 11 - This is a critical step, so be

sure to understand what has to occur before

you glue things into place. Slide the tube

into the rear of the blow-molded tube from

the plastic model kit. Refer to Step 7 of the

instruction sheet that came with the Space-

monkey Models V-2/A4 kit in how the nozzle

insert is aligned with the fin location of the

blow molded tube. Looking from the front

side of the blow molded tube, check to see

if the paper centering ring is making good

contact with the inside edge of the blow

mold tube. When you are sure you under-

stand how everything fits together, remove

the parts and glue them together using thick

super glue.

Step 6

Step 7

Step 8

Step 9

Step 10

Step 11

Page 3