Data-Tronix DT-UPS-500 Manuel - Sayfa 4

UPS Data-Tronix DT-UPS-500 için çevrimiçi göz atın veya pdf Manuel indirin. Data-Tronix DT-UPS-500 8 sayfaları. Dt-ups series

CONNECT EQUIPMENT TO UPS
Now connect your lour load to be protected (computer, monitor etc.) to the AC Output receptacles at the rear of the
UPS (Reference the figure 4).
MAINS
OUTLET
Figure 4
Enable the UPS by turning on the Power ON/OFF switch, which is situated on the front panel.
The UPS is now ready to use. Switch on your equipment.
BATTERY MAINTENANCE/BATTERY CHARGING.
AFTER SHIPMENT FROM THE FACTORY, THE BATTERY WILL NEED A FULL RECHARGING. OF AT LEAST
12 HOURS.
IF NOT USED FOR A LONG PERIOD OF TIME, THE BATTERY WILL START
SELF-DISCHARGING, WHICH MAY RESULT IN A SHORTER SERVICE LIFE OF THE BATTERY OR MAY
EVEN CAUSE DAMAGE TO IT DURING THE WARRANTY PERIOD. CARE SHOULD BE TAKEN TO AVOID
EXCESSIVE TEMPERATURE AROUND THE UPS, WHICH COULD ALSO RESULT IN REDUCING SERVICE
LIFE OF THE BATTERY. TO ACHIEVE MAXIMUM SERVICE LIFE FROM THE BATTERY THE ABOVE
INSTRUCTIONS SHOULD BE FOLLOWED.
The UPS battery charges whenever the UPS is connected to utility power & is switched ON. It typically requires twelve
hours to charge fully. Operating runtime is reduced until the battery is fully charged.
TEST THE UPS
To test UPS on battery back-up, disconnect the power cord and observe backup Indicator lights. Your PC or other
connected equipment should continue to function normally until the UPS battery is drained of power.
UPS Indicators and Controls
AC NORMAL(green light)
CHARGING(yellow light )
BACKUP(red light)
Figure 8 (LED display mode 1)
AC NORMAL(green light)
BACKUP(yellow light)
FAULT(red light)
POWER
UPS
POWER
UPS
Figure 9 (LED display mode 2)