Data-Tronix DT-UPS-500 Посібник - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник для ДБЖ Data-Tronix DT-UPS-500. Data-Tronix DT-UPS-500 8 сторінок. Dt-ups series

CONNECT EQUIPMENT TO UPS

Now connect your lour load to be protected (computer, monitor etc.) to the AC Output receptacles at the rear of the

UPS (Reference the figure 4).

MAINS

OUTLET

Figure 4

Enable the UPS by turning on the Power ON/OFF switch, which is situated on the front panel.

The UPS is now ready to use. Switch on your equipment.

BATTERY MAINTENANCE/BATTERY CHARGING.

AFTER SHIPMENT FROM THE FACTORY, THE BATTERY WILL NEED A FULL RECHARGING. OF AT LEAST

12 HOURS.

IF NOT USED FOR A LONG PERIOD OF TIME, THE BATTERY WILL START

SELF-DISCHARGING, WHICH MAY RESULT IN A SHORTER SERVICE LIFE OF THE BATTERY OR MAY

EVEN CAUSE DAMAGE TO IT DURING THE WARRANTY PERIOD. CARE SHOULD BE TAKEN TO AVOID

EXCESSIVE TEMPERATURE AROUND THE UPS, WHICH COULD ALSO RESULT IN REDUCING SERVICE

LIFE OF THE BATTERY. TO ACHIEVE MAXIMUM SERVICE LIFE FROM THE BATTERY THE ABOVE

INSTRUCTIONS SHOULD BE FOLLOWED.

The UPS battery charges whenever the UPS is connected to utility power & is switched ON. It typically requires twelve

hours to charge fully. Operating runtime is reduced until the battery is fully charged.

TEST THE UPS

To test UPS on battery back-up, disconnect the power cord and observe backup Indicator lights. Your PC or other

connected equipment should continue to function normally until the UPS battery is drained of power.

UPS Indicators and Controls

AC NORMAL(green light)

CHARGING(yellow light ）

BACKUP(red light)

Figure 8 (LED display mode 1)

AC NORMAL(green light)

BACKUP(yellow light)

FAULT(red light)

POWER

UPS

POWER

UPS

Figure 9 (LED display mode 2)