DURRIDGE RAD7 Bağlantı Kılavuzu - Sayfa 3

Ölçüm Cihazları DURRIDGE RAD7 için çevrimiçi göz atın veya pdf Bağlantı Kılavuzu indirin. DURRIDGE RAD7 4 sayfaları. Passive, slow response radon in water accessory
Ayrıca DURRIDGE RAD7 için: Bluetooth Bağlantı Kılavuzu (4 sayfalar), Kullanıcı Kılavuzu (7 sayfalar), Kullanıcı Kılavuzu (15 sayfalar)

Sayfayı Yazdır

Conﬁguring the SD1000 Adaptor

Customers who purchase the Parani SD1000 adaptor from DURRIDGE will receive the adaptor

preconﬁgured for use with the RAD7. If the adaptor's settings are later modiﬁed, or if the adaptor is

purchased from another vendor, it may be necessary to reconﬁgure the adaptor as described below.

Otherwise reconﬁguration is not necessary, and the following instructions can be skipped.

Required items

• Parani SD1000 Serial to Bluetooth Adaptor, power cable, and USB power source

• Computer running Microsoft Windows

• Startech USB to Serial Adaptor Cable (included with the RAD7)

• Startech USB to Serial Adaptor Cable driver software, available from the DURRIDGE website at

https://durridge.com/software/software-drivers/

• Null Modem Adaptor (included with the RAD7) or an equivalent cable

• ParaniWin software for Windows, available from the DURRIDGE website at: 

http://durridge.com/software_downloads/drivers_and_utilities/setup_ParaniWin-v1.0.8.exe

Procedure

1. Make sure the Parani SD1000 Serial to Bluetooth Adaptor is powered OFF and make sure that all

of its DIP Switches are set to the OFF position.

2. Install the driver and application software listed in the Required Items section above.

3. Physically connect the SD1000 adaptor to the computer, using the StarTech USB to Serial adaptor

cable and the null modem adaptor, as pictured in Figure 1, below.  

Figure 1: Connecting the SD1000 to the computer. This requires the Null Modem adaptor and

StarTech serial to USB adaptor cable.

4. Connect the SD1000 adaptor's USB-based power cable to a powered USB socket, and turn the

SD1000's power switch ON.

5. Launch the ParaniWin application on the computer. A dialog box titled UART Setting will appear,

prompting you to specify a number of parameters, as shown in Figure 2 on the following page.

Conﬁgure the settings as follows:

• Specify the Serial Port. It may require trial and error to determine the correct port.

• Set the Baud Rate to 9600.

• Set the Parity None.

• Set the StopBit to 1.

Continued on next page 