CBE DS-520AN Kullanım Kılavuzu - Sayfa 4

Endüstriyel Ekipmanlar CBE DS-520AN için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. CBE DS-520AN 13 sayfaları.

FUNCTIONS

MINIMAL VOLTAGE CONTROL

An electronic device switches all the 12V mains off, when the leisure battery reaches the minimal

voltage level of 10V. It is possible to switch on again all the mains for about 1 minute by switching

off and then on again the main switch.

They are also automatically switched on again when the voltage is > 12V.

The fridge, the electrical step and the mains powered directly from B2 are excluded from this

device.

AMPEREMETER

The amperemeter is inside the DS-520AN module.

- It measures the current of the leisure battery, users' consumption and recharge through battery

charger, engine alternator and solar panels.

- Measure range is: -40A ÷ +40A.

- Measure is carried out as difference between charging and discharging currents: a positive value

indicates a charging current, a negative value indicates a discharging current.

To measure the charging of a sole source (battery charger, alternator or solar panels), turn off all

users and other recharging sources.

To measure the consumption of a sole user, disconnect all recharging sources and all

uninterested users.

DRINK WATER TANK REFILLING

This function is used during the drink water tank refilling and it shows the level reached by the

water.

You switch on this function by visualizing the drink water tank and by keeping pushed the tank

switch for more than 3 seconds.

When this function is on, you see getting lightened, in sequence, the horizontal segments of the

number ref. 18 and the panel emits sounds in order to warn that the tank is getting filled:

1 short sound at 75%, 2 short sounds at 85% and 1 long sound at 95%.

ELECTRONIC TANKPROBE

The electronic tankprobe mod. "SPE" is a capacitive tankprobe. It is powered with 5V and a back-

signal from 0 to 2,5V.

Each 8 seconds the microprocessor gives power to the tankprobe; it is also powered each time you

pust the tank-test button. This was studied in order to avoid useless consumption.

The tank probe has been already programmed by CBE, but it is still possible to check the correct

working of the tankprobe and its setting by following these instructions:

- activate the function

- in this way the tankprobe gets a continue power supply of 5V, so that you can control with a

voltmeter the back-signal of 2,5V and you can also adjust, by using the tankprobe's trimmer,

possible small variations. (e.g.: value "0 V" = 0 %, value "2,5 V" = 100 %).

- switch the main switch off and then on again.

For this test the tank must be full.

Attention:

"DRINK WATER TANK REFILLING"