Dataman Cipher 1660 BT Portable Hızlı Başlangıç Kılavuzu - Sayfa 6

Barkod okuyucu Dataman Cipher 1660 BT Portable için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Dataman Cipher 1660 BT Portable 9 sayfaları. Ccd scanners

Sayfayı Yazdır

Inter record download delay:-

Before undertaking any data downloading activity the first bar code command sequence to be

used should be the inter record download delay instruction. This command will cause the

Downloading data:-

Once the download delay has been set the actual stored data can be downloaded to the

server, the targeted computer program should be prepared to receive the data. In a similar

fashion to the download delay instruction described above the data is downloaded by firstly

scanning the command bar code "Begin Instruction Mode" followed by the command bar

code "Transmit Stored Data" followed by the "Finish Instruction Mode" command bar

code. See command bar codes 1, 5, 6 highlighted below.

It should be noted that immediately following the instruction to download data the 1660 BT

After the data has been successfully

downloaded the data in memory can be

cleared if needed and the unit again taken

remotely to collect more data.

See command bar codes 1, 4, 5, 6

highlighted right.

This

action

data

downloading and data clearing can be

repeated as often as required until the

asset recording or stocktaking process is

completed.

pauses a few seconds before downloading

commences, this can lead to concerns that the

instruction has not succeeded.

(Please wait).

Clear data memory:-

collection,

data

1660 BT to pause a commanded time

between each set of data (bar code)

downloaded and hence give time for the

receiving program to process the data.

In order to send this instruction, scan the

command bar code "Begin Instruction

Mode" then the command bar code for the

desired delay period (0.25 sec is usually

adequate)

followed

Instruction Mode" command bar code.

This download delay period instruction

sequence

must

downloading data and is required to be

sent once only, all subsequent data

download operations will use the same

delay period. See Command bar codes 1,

2, 6 highlighted left.

the

"Finish

sent

prior