4M Robotic Hand Talimatlar - Sayfa 2

Robotik 4M Robotic Hand için çevrimiçi göz atın veya pdf Talimatlar indirin. 4M Robotic Hand 2 sayfaları.

C. ASSEMBLY

Remarks: You need to tie a number of knots on the fishing line in the following assembly

instructions. Fishing line is elastic and the knots may loosen themselves over time. Use the

measurement templates which indicate the knot positions and lengths of line required.

Always tie a few knots to secure the knot in place. Allow extra fishing line when tying the

knots. You can always cut away the excess length after the knots are finished.

1. Starting with the little finger, examine the finger tubes. The end with the narrow ring is

the tip and the end with the wider ring is the finger root, which slots into the hand frame.

Cut a piece of fishing line 28 cm long. Use TEMPLATE A below for measurement. Place the

fishing line on the template and mark the three knot positions with a marker or ball pen on

the fishing line. Thread the line through a finger end cap. Tie a few knots at the first knot

position to stop it slipping back through the hole in the cap.

2. On the inside of the rings on the finger tubes are small sleeves. Feed the other end of the

fishing line through all the sleeves to the end of the finger tube.

3. Now slot the end cap into the end of the finger.

4. Hold the hand frame with the plastic loops facing upwards. Push the finger tubeʼs root

end into the first loop. The sleeves holding the fishing line must also be uppermost so that

the fingers will bend the correct way.

5. Repeat 1 to 4 steps again for the ring finger (the one next to the little finger).

6. Tie the fishing lines from the first two fingers together at the second knot position. The

tied lines should be tight after they are tied. This will allow the fingers to bend properly

when the lines are pulled.

7. Thread the ends of the two fishing lines through the first hole in the square holder frame.

Tie them into the hole in a pull ring at knot position 3. By now the pull ring should be touch-

ing the upper edge of the frame. Cut off any excess fishing line after you have tied all the

knots. Try pulling the pull ring — the two fingers should bend properly. If they donʼt, re-do

the knots.

8. Repeat the above steps for the middle and index finger tubes.

9. For the thumb, cut a piece of fishing line 23 cm long and mark the two knot positions

following TEMPLATE B below. Now follow steps 1 to 4. Unlike the first four fingers, the

thumb does not share a pull ring with another finger. Just tie the line directly to the pull ring

at the second knot position.

Check all knots are secured and pull the rings to see if all fingers bend properly. Cut away

the excess length. Congratulations! Your Robot Hand is complete.

TEMPLATE A

knot 1

TEMPLATE B

knot 1

knot 2

tie a few knots

tie a knot

tie a few knots

knot 3