Datapath VisionLC-HD Manuel - Sayfa 2
PCI Kart Datapath VisionLC-HD için çevrimiçi göz atın veya pdf Manuel indirin. Datapath VisionLC-HD 2 sayfaları. Dual and single channel live capture cards
Ayrıca Datapath VisionLC-HD için: Kullanıcı Kılavuzu (15 sayfalar)
Sayfayı Yazdır
PACKING LIST
Your packing box should contain the following items:
The VisionLC-HD - Single channel live capture card.
Half height bracket.
Installation CD-ROM.
(For latest drivers go to www.datapath.co.uk).
NOTE:
All plug-in cards are static sensitive and are packed in
antistatic materials. Please keep the card in its
packaging until you are ready to install.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
HARDWARE INSTALLATION
You are likely to need a flat blade and/or a cross head
screwdriver for the installation of the VisionLC-HD card; it
would be useful to have these to hand before you begin.
Power down the PC (including peripherals), switch off at
the mains and disconnect all the cables connected to the
computer, noting the positions for accurate reconnection
Remove the PC cover.
Locate a vacant PCIe slot (x4 or higher) on the motherboard
and remove the backing plate (retain all screws) .
If in doubt consult your motherboard documentation to
correctly identify a PCIe (PCI-express) slot. If the card is
forced into a 32 or 64 bit PCI or PCI-X slot it will be
irreparably damaged when the system is powered up and
the warranty will be void.
Remove the VisionLC-HD card from its packaging and
secure it firmly into the empty PCIe slot.
Screw the VisionLC-HD bracket to the back panel of the
PC and replace the cover. Connect the cable (not supplied)
distributing the signals to the connectors on the
VisionLC-HD card.
Reconnect all cables to the PC.
SOFTWARE INSTALLATION
Insert the Datapath CD into your CD drive, the CD will
autorun and display the following dialogue. If the CD
drive fails to autorun browse the CD and locate and
double click the setup.exe file.
Click on Install Drivers... and follow the installation
Wizard instructions as prompted.
We suggest that you regularly visit the Datapath web site
for information on updated drivers.
www.datapath.co.uk
It is strongly recommended that you read the detailed
help instructions on completion of the installation. Each
help topic may be printed for ease of use.