Aussie 4280 Walk-A-Bout Gas Kullanıcı Kılavuzu - Sayfa 8

ızgara Aussie 4280 Walk-A-Bout Gas için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Aussie 4280 Walk-A-Bout Gas 16 sayfaları. Lp gas grill

Sayfayı Yazdır

Lighting the Grill Using the Pulse-Spark Ignitor

1. Open the Hood.

2. Push LEFT Burner Control Knob on Control Panel in and turn 90 degrees counterclockwise to the High position.

3. Push the Igniter Button in repeatedly until the Burner is lit (Fig. 2). Listen for the click indicating spark ignition, and

look to make sure the Burner is lit.

4. From the "Off" position, light the other Right hand burner. Your grill has a Crossover Ignition System that allows the

Right burner to light from the Left. Confirm the Left burner is lit before attempting to light the Right burner.

If a Burner goes out during operation, turn all Control Knobs to the "Off" position. Open Hood and wait five minutes

before attempting to relight the grill to allow any accumulated gas to dissipate.

If Burners fail to light after three to four attempts, turn all Control Knobs to the "Off" position and allow any accumu-

lated gas to dissipate. Check for igniter spark by pushing igniter button and looking at the igniter tip. If no spark, adjust

gap between electrode tip and burner to 3/16" (Fig. 3). If still no spark, see Troubleshooting Section.

Wait five minutes; then repeat the lighting procedures.

The Burner can also be lit manually, see Manual Lighting of the Grill.

Should you notice that your Burner(s) are getting hard to light or the flame is not as hot as it once was, refer to the

"How to Clean your Burners" to remove any possible obstructions.

Left Main Burner

Control Knob in

OFF position

Fig. 2

Manually Lighting the Grill

1. Open the Hood.

2. IMPORTANT:

Make sure Control Knobs are turned "Off."

3. While holding a lit match near the LEFT burner, push LEFT

Burner Control Knob in and turn 90 degrees counterclock-

wise to the High position. (Fig. 4)

Step 3 may also be accomplished by inserting the lit match

through one of the holes in the bottom of the bowl near the

LEFT burner.

4. Your grill has a Crossover Ignition System that allows the

Right burner to light from the Left. Confirm the Left burner is

lit before attempting to light the Right burner.

If a Burner goes out during operation, turn all Control Knobs to the

"Off" position. Open Hood and wait five minutes before attempting

to relight the grill to allow any accumulated gas to dissipate.

Igniter Button

Fig. 3

3/16" gap

If no spark, adjust gap between

electrode tip and burner to 3/16"

LEFT Burner

Fig. 4

Match