AUSSIE TONNEAU ATB01002 Montaj Talimatı - Sayfa 2

Otomobil Aksesuarları AUSSIE TONNEAU ATB01002 için çevrimiçi göz atın veya pdf Montaj Talimatı indirin. AUSSIE TONNEAU ATB01002 2 sayfaları. For ford falcon xd xe xf xg xh single cab 1979 – 1999

Sayfayı Yazdır
AUSSIE TONNEAU ATB01002 Montaj Talimatı
2.3 FITTING MULTI-FIT BAR
1. Insert solid bar pieces into either end of hollow tube. Adjust bar so it fits between bar bracket holders
with the holes facing to the ground (so the grub screws don't rub against the tonneau), as shown above
and then with a white pencil make a mark through the small holes of the hollow bar onto the solid ends.
This is where you will drill a hole to the depth of about 1-2mm (do not go any further)
2. Join the pieces back together and screw grub screws through the hollow bar into the holes that you
drilled. Make sure you do not over tighten the grub screws. Refit the bar. You may kink the bar in the
middle to give it some extra height to assist with water runoff.