Cookology GH601SS Kullanıcı Kılavuzu - Sayfa 17

Hob Cookology GH601SS için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Cookology GH601SS 19 sayfaları. Built in gas hob

o Place a small bladed screwdriver on the screw to adjust

the minimum flow (as shown in the image on the left).

o Unscrew the adjusting screw, in order to increase the gas

flow or tighten the adjusting screw to decrease the gas

flow.

o The correct adjustment is obtained when the flame has a

length of about 3 – 4 mm.

o For butane/propane gas, the adjusting screw must be

tightly screwed in.

o Make sure that the flame does not go out by quickly

turning from maximum flow to minimum flow. If it does

then

remove

adjustments to the gas flow, testing it again once the

adjustment has been made.

o Repeat this process for each one of the gas taps.

o Install the panel and refit the caps, flame spreaders and

knobs after finished the adjustment.

IMPORTANT: WHERE THIS APPLIANCE IS

MARINE CRAFT OR IN CARAVANS, IT SHAL NOT BE USED AS

A SPACE HEATER.

Gas tap maintenance

These

carried out by a GASSAFE registered engineer.

IMPORTANT:

operations, disconnect the appliance from the gas and

electricity supplies.

the

control

maintenance

Before

carrying

knob

and

operations

MUST

out

any

make

further

INSTALLED IN

ONLY

maintenance