Cookson FDO-A10E Kullanıcı El Kitabı - Sayfa 7

Kapı açma sistemi Cookson FDO-A10E için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Cookson FDO-A10E 19 sayfaları. Industrial duty fire door operator

Sayfayı Yazdır

MAKE SURE THE LIMIT NUTS ARE POSITIONED BETWEEN THE LIMIT SWITCH ACTUATORS

BEFORE PROCEEDING WITH ADJUSTMENTS. MAKE SURE OPENING AND THE AREA NEAR

DOOR/OPERATOR AND MECHANISMS ARE CLEAR OF OBSTRUCTIONS AND PERSONNEL.

TO AVOID SERIOUS PERSONAL INJURY OR DEATH FROM ELECTROCUTION, DISCONNECT

ELECTRIC POWER BEFORE MANUALLY MOVING LIMIT NUTS.

1) To adjust limit nuts depress retaining plate to allow nut to spin freely. After adjustment,

release plate and ensure it seats fully in slots of both nuts.

2) To increase door travel, spin nut away from actuator. To decrease door travel, spin limit

nut toward actuator.

3) Adjust open limit nut so that door will stop in open position with the bottom of the door

even with top of door opening.

4) Repeat Steps 1 and 2 for close cycle. Adjust close limit nut so that actuator is engaged

as door fully seats at the floor.

5) Connect Photo Electric Sensors per the wiring diagram on page 10 and test operation.

6) Connect sensing edge to controller terminals 3 & 10 and test operation - if equipped.

OPEN LIMIT SWITCH

RETAINING

PLATE

9001(7) ECN 1057 4/10/010

LIMIT SWITCH ADJUSTMENT

WARNING

LIMIT NUTS

CLOSE LIMIT SWITCH