4x4 TOUGH 17-031000 Kullanım Kılavuzu - Sayfa 10

Uzaktan Çalıştırıcı 4x4 TOUGH 17-031000 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. 4x4 TOUGH 17-031000 12 sayfaları.

Sayfayı Yazdır

2.0. Well Below the Voltage Level Required to Start the Vehicle

Follow this procedure when the Jump Starter's Fault/Override indicator (B) blinks, but the Jump

Starter is unable to be fully charged by the de cient battery.

There are several very important safety aspects which need to be understood and practiced

prior to activating the Jump Starter Bypass Mode.

It is important to read through the bullet points below in their entirety and fully understand

prior to proceeding further.

• The vehicle's positive lead to the disabled battery must be disconnected.

• The Jump Starter's positive lead is connected to the disconnected positive battery lead, and

the Jump Starter's negative lead connected to the negative battery

vehicle's negative lead attached).

• The critical point in the process is to reconnect the vehicle's disconnected positive lead to

the positive battery post, whilst maintaining connection of both Jump Starter leads.

• BE AWARE - Unless due care is exercised, it is possible to dislodge the Jump Starter leads

while reattaching the positive vehicle lead. Should this happen the vehicle's electrical system

could be damaged.

• For the above reason, the reconnection process must be practiced, and only when you are

con dent in this process, should you proceed to implement the processes of charging the

Jump Starter and starting the vehicle.

CAUTION: Ensure the Jump Starter is switched OFF whilst mastering this technique!

Failure to reconnect the vehicle's lead to the battery post prior to disconnection of either of the

Jump Starter leads may cause damage to the vehicle's electrical system.

Steps required to start the vehicle:

Prepare the disabled vehicle to receive the Jump Starter - disconnect the vehicle's battery

2.1

lead from the battery post (Fig.3).

Charge the Jump Starter from a power source other than the de cient battery: a

2.2

battery in another vehicle, a 12V DC outlet (G) in another vehicle, a USB charging outlet (F).

(refer speci cations for a guide to charging times).

Connect the Jump Starter's positive lead to vehicle's positive battery lead (Fig.4).

2.3

Activate the Bypass Mode by holding down the On/O Start Button (D) until a series

2.4

of beeps is heard and the Fault/Override indicator light (B) becomes a xed green. This

indicates the Bypass Mode has been activated.

Attach the negative Jump Starter lead to the battery's negative post (still connected)

2.5

(Fig.5).

Turn the ignition on and the vehicle should start. If the vehicle fails to start, repeat

2.6

steps 2.1 – 2.5 for a maximum of 5 times. If the vehicle still does not start, stop and

continue with 3.0 as detailed below.

After the vehicle starts, carefully reconnect the vehicle's disconnected positive battery

2.7

lead to the positive battery post, ensuring both Jump Starter leads remain connected (Fig.6)

Once the vehicle's positive lead has been reconnected to the post, you can safely

2.8

disconnect the Jump Starter's positive lead. (Fig.7).

post

(which will have the