4x4 TOUGH 17-031000 Kullanım Kılavuzu - Sayfa 11
Uzaktan Çalıştırıcı 4x4 TOUGH 17-031000 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. 4x4 TOUGH 17-031000 12 sayfaları.
Sayfayı YazdırAfter disconnecting the Jump Starter's positive lead, deactivate Bypass Mode by pressing
2.9
the ON/OFF button (D), once. The Fault Override indicator light (B) will extinguish (con rming
the Bypass Mode has been deactivated).
Disconnect the negative Jump Starter lead.
2.10
Before switching o the vehicle, take it for a short drive to allow the de cient battery
2.11
to recharge.
3.0. Completely Without Charge "dead battery"
Follow this procedure when the Jump Starter's Fault/ Override indicator does not blink, while
connected to the disabled vehicle's battery.
Connect the Jump Starter to a power source, other than the de cient battery: a battery in
3.1
another vehicle, a 12 V DC outlet outlet (G) in another vehicle, a USB charging outlet (F).
(refer speci cations for a guide to charging times).
Press the Charging Button (C). The Jump Starter will accumulate charge.
3.2
Once the Jump Starter has fully charged i.e. both the top green lights are showing a xed
green (A), disconnect the Jump Starter from the power source and connect to the disabled
vehicle's battery. Connect the red clamps to the positive terminal and the black clamp to
the negative terminal.
Activate the Bypass Mode by holding down the On/O Start Button (D) until a series of
3.3
beeps is heard and the Fault/Override indicator light (B) becomes a xed green. This
indicates the Bypass Mode has been activated.
Turn the ignition on and your vehicle should start. Should the vehicle fail to start, repeat
3.4
steps 3.1 - 3.3 for a maximum of 5 times. If the vehicle still does not start, contact one of our
customer service team for further assistance on 1300 883 104.
After the vehicle has started, disconnect the positive Jump Starter clamp leads, then
3.5
press the On/O Start Button (D) to deactivate the Bypass Mode. After the Fault/Override
Indicator light (B) has extinguished (con rming the Override Mode has been deactivated)
disconnect the negative clamp lead.
Before switching o the vehicle, take it for a short drive to allow the de cient battery to
3.6
recharge.
PHONE CHARGING
In the event of an emergency, you can charge your mobile phone from a fully charged Jump
Starter (methods described above). Plug the charging cable of your phone into the USB port
(E) located at the bottom of the unit. Charge time will be approximately 20 minutes.
CARE AND MAINTENANCE
Simply wipe clean with a soft damp cloth if required.
DO NOT
dismantle the unit, there are no user-serviceable parts inside.
DISPOSAL
When the product is no longer required, dispose of it in an environmentally protective way.
Contact your local waste authority for recycling information.
11