BENDIX Wingman FLR20 Kurulum Talimatları Kılavuzu - Sayfa 3

Otomobil Aksesuarları BENDIX Wingman FLR20 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. BENDIX Wingman FLR20 8 sayfaları. Radar changeover kits

Sayfayı Yazdır

Have Speciﬁc Openings

for Routing the Harness

FIGuRe 5 - radar sensor installation (exploded

view)

12. See Figure 5. With the connector pointing to the

passenger side of the vehicle when installed, align the

holes in the radar sensor with the adjusters. Install the

new radar onto the adjusters by pressing, by hand, with

moderate force, on the front surface of the radar. Verify

that all three clips at the top of the adjusters have fully

engaged into the radar.

Install the Harness

13. Insert the connector into the Bendix

14. Slide the orange Connector Position Assurance (CPA) tab

to the right, making sure the connector is fully engaged.

15. Route the harness through the back of the bracket, firmly

securing as necessary.

16. Install the Radar Assembly onto the vehicle by using

two (2) bolts removed during disassembly. Torque to

vehicle OE specifications.

17. aLIGn tHe RadaR, per the Appendix on pages 4-6

or refer to Bendix Service Data Sheet, SD-61-4960,

available for download or order from www.bendix.com.

Remove the steel clip or plate before returning the

vehicle to service. When removing stretch-release

adhesive strips, be sure to pull directly down on the tab

provided and clean any adhesive residue that may be

present on the sensor.

Note: Most Brackets

Bracket Varies

FLR20

™

18. For installations where the bracket has a cover, insert

the supplied mounting screws through their respective

washers. These are then inserted through the cover

and retained by nylon washers on the other side. See

Figure 6. Typically the radar will be aligned before the

cover is installed.

FIGuRe 6 - nylon washer installation (where

needed)

Using a Phillips screwdriver, attach the cover to the

bracket using the two screws.

19. Re-install the vehicle's bumper if it was necessary

to remove it for this installation, following the OEM's

approved practices. Check for radar clearance as shown

in the Service Data Sheet. Some bumper modification

radar.

may be necessary.

20. Return the radar sensor removed from the vehicle,

for core return credit using the Bendix Upgrade Tag

(BW1829) supplied in the kit. The radar must be carefully

packaged using suitable materials in a separate container

from other core returns.

Bendix technical assistance team

For direct telephone technical support, call the Bendix Tech

Team at:

1-800-AIR-BRAKE (1-800-247-2725), option 2. Tech Team

members are available Monday through Friday, 8:00 a.m. to

6:00 p.m. ET.

Or, if you prefer, e-mail them at: [email protected].

Please have the following information ready when you

contact the Bendix Tech Team: Bendix product model

number; part number and configuration; vehicle make and

model.

Mounting Screw

Washer

Nylon

Retaining

Washer