BENDIX Wingman FLR20 Panduan Petunjuk Instalasi - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Aksesori Mobil BENDIX Wingman FLR20. BENDIX Wingman FLR20 8 halaman. Radar changeover kits

Halaman Cetak
Have Specific Openings
for Routing the Harness
FIGuRe 5 - radar sensor installation (exploded
view)
12. See Figure 5. With the connector pointing to the
passenger side of the vehicle when installed, align the
holes in the radar sensor with the adjusters. Install the
new radar onto the adjusters by pressing, by hand, with
moderate force, on the front surface of the radar. Verify
that all three clips at the top of the adjusters have fully
engaged into the radar.

Install the Harness

13. Insert the connector into the Bendix
14. Slide the orange Connector Position Assurance (CPA) tab
to the right, making sure the connector is fully engaged.
15. Route the harness through the back of the bracket, firmly
securing as necessary.
16. Install the Radar Assembly onto the vehicle by using
two (2) bolts removed during disassembly. Torque to
vehicle OE specifications.
17. aLIGn tHe RadaR, per the Appendix on pages 4-6
or refer to Bendix Service Data Sheet, SD-61-4960,
available for download or order from www.bendix.com.
Remove the steel clip or plate before returning the
vehicle to service. When removing stretch-release
adhesive strips, be sure to pull directly down on the tab
provided and clean any adhesive residue that may be
present on the sensor.
Note: Most Brackets
Bracket Varies
®
FLR20
™
18. For installations where the bracket has a cover, insert
the supplied mounting screws through their respective
washers. These are then inserted through the cover
and retained by nylon washers on the other side. See
Figure 6. Typically the radar will be aligned before the
cover is installed.
FIGuRe 6 - nylon washer installation (where
needed)
Using a Phillips screwdriver, attach the cover to the
bracket using the two screws.
19. Re-install the vehicle's bumper if it was necessary
to remove it for this installation, following the OEM's
approved practices. Check for radar clearance as shown
in the Service Data Sheet. Some bumper modification
radar.
may be necessary.
20. Return the radar sensor removed from the vehicle,
for core return credit using the Bendix Upgrade Tag
(BW1829) supplied in the kit. The radar must be carefully
packaged using suitable materials in a separate container
from other core returns.
Bendix technical assistance team
For direct telephone technical support, call the Bendix Tech
Team at:
1-800-AIR-BRAKE (1-800-247-2725), option 2. Tech Team
members are available Monday through Friday, 8:00 a.m. to
6:00 p.m. ET.
Or, if you prefer, e-mail them at: [email protected].
Please have the following information ready when you
contact the Bendix Tech Team: Bendix product model
number; part number and configuration; vehicle make and
model.
Mounting Screw
Washer
Nylon
Retaining
Washer
3