Airwell RC5 Manuel - Sayfa 8

Uzaktan Kumanda Airwell RC5 için çevrimiçi göz atın veya pdf Manuel indirin. Airwell RC5 8 sayfaları. For room air conditioner
Ayrıca Airwell RC5 için: Programlama ve Kullanım Kılavuzu (11 sayfalar)

Sayfayı Yazdır

OPERATION

ADJUSTING THE AIR FLOW DIRECTION

HORIZONTAL (manual)

The horizontal air flow can be adjusted by moving

the vertical vanes to the left or right, as indicated

in the following figures.

VERTICAL (with remote control unit)

The remote control gives you the possibility to

control the flap in two way:

Push the

button to start the flap sweep. If

you push again the flap stops immediately.

Set vertical vanes to the front position during

COOLING/DRY operation if humidity is high.

If the vertical vanes are set to the left-most

or right-most position, condensation will form

around the air outlet and drip off.

Do not move the flap with your hands when the

air conditioner is running.

NOTES

The flap automatically closes when the unit is

off.

During the heating operation, the fan speed

will be very low and the flap will be in the

horizontal position until the air being blown

out of the unit begins to warm. Once the air

warms up, the flap position and fan speed

change to the settings specified with the

remote control.

Use the FLAP button on the remote control to

adjust the position of the flap. If you move the

flap by hand, the factual flap position and the

flap position on the remote control may no longer

match. If this should happen, shut off the unit,

wait for the flap to close, and then turn on the

unit again; the flap position will now be normal

again.

Do not have the flap pointed down during cooling

operation. Condensation may begin to form

around the air vent and drip down.