Dyna-Form Mercury Advance Kullanıcı Kılavuzu - Sayfa 8

Tıbbi Ekipman Dyna-Form Mercury Advance için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Dyna-Form Mercury Advance 12 sayfaları. Pressure relieving mattress suitable for use with patients at very high risk of pressure ulcer damage

Sayfayı Yazdır

D Y N A - F O R M M E R C U R Y A D V A N C E

5.1 Low / High Settings

The Dyna-Form Mercury Advance Mattress, in Alternating Mode, has two pressure settings. The

initial setting that the control unit will revert to upon set up is "Low". The "Low" comfort setting

is ideal for the lighter patient or those who feel discomfort when on a normal alternating air type

mattresses system. However, for patients with existing pressure damage or those at Very High

Risk, it is recommended that dependant on the clinical judgement of the clinician,

the "High" setting is activated by pressing the +/- button once, which is located on top of the

Control Unit.

In "High" Mode the Control Unit attains more of the characteristics of an alternating air mattress

system whilst still utilising the advantages of the static foam inserts. Repeatedly pressing the

'mode' button enables the Low & High modes to be selected in turn.

5.2 CPR Deflation

The CPR system consists of a manually operated button located on the Air Inlet connector

attached to the Control Unit. By pressing the Red Button, which will release the connector locking

system, the user can remove the connector unit which will deflate the mattress air system back to

that of a static foam mattress.

Note: After a short period as the Mattress deflates the 'Low Pressure' Audible Warning is

activated and can be cancelled by switching the Control Unit off.

5.3 Troubleshooting

For assistance (if needed) in setting up, using or maintaining the Mercury Advance System, or to

report unexpected operation or events, please contact Direct Healthcare Services on the contact

details on the reverse of this manual.

6. Transportation

To change the location of the mattress, remove the Umbilical Cord and allow the mattress

to return to its Static Mattress form. Switch off the Control Unit using the on/off switch and

disconnect the electrical supply cable from the mains socket. The mattress can now be moved

to a new location where it must immediately be reconnected to the mains electrical supply and

the Control Unit switched back on. Once the Mattress has been refilled, the 'Alternating' mode

will automatically revert back to the Low setting and should be reselected to High should this be

desired by the clinician.

Warning: The Mattress will not ' a lternate' when disconnected from Control Unit and /or the mains

electrical. Also, refer to environmental conditions section at rear of this manual.

7. Warnings

Warning conditions are indicated by a flashing red display accompanied by an Audible Warning.

In each case the user should respond by turning the Control Unit's switch off and investigating the cause.

7.1 High Pressure Warning

This condition could be caused, for example by a kinked Umbilical Hose or visitors,

and others, sitting suddenly on the Mattress.

7.2 Low Pressure Warning

This condition could be caused, for example, by incorrect fitting of the air inlet connector,

opening of the CPR Valve or a leak in the Mattress due to a cut or puncture.

7.3 Mains Failure Warning

This condition may be caused, for example if Mains power is lost.

D I R E C T H E A L T H C A R E S E R V I C E S . C O . U K