Dyna-Glo RMC-55R7 Kullanıcı El Kitabı - Sayfa 8

Isıtıcı Dyna-Glo RMC-55R7 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Dyna-Glo RMC-55R7 20 sayfaları. Portable kerosene heater
Ayrıca Dyna-Glo RMC-55R7 için: Kullanıcı El Kitabı (20 sayfalar)

Sayfayı Yazdır

ADJUSTING THE WICK

After lighting the heater, it is important to check the heater flame within the first 5-7 minutes of operation. After 5-7

minutes of operation, you should use the wick adjuster knob to obtain the proper flame height (see Fig 8). IF THE

FLAME IS TOO YELLOW, TURN THE WICK ADJUSTER KNOB DOWN SLIGHTLY UNTIL YOU GET THE BLUE

FLAME INDICATED IN FIG.8. IF THERE IS NO FLAME, OR A VERY LOW FLAME, TURN THE WICK

ADJUSTER KNOB UP SLIGHTLY UNTIL YOU GET THE BLUE FLAME INDICATED IN FIG.8.

VERY FINE ADJUSTMENTS TO THE FLAME CAN BE MADE BY GRABBING THE BURNER KNOB AND

MOVING THE BURNER FROM SIDE TO SIDE UNTIL THE BLUE FLAME IS EVENLY DISTRIBUTED.

CAUTION : Do not grab the burner knob once the heater has reached normal operating

temperature and the flame has stabilized. The burner knob is very hot during operation.

As you continue to operate the heater, the temperature of the heater and the temperature of the room will continue

to change. As the heater warms up, the kerosene in the tank will vaporize faster, and this could require adjusting

the wick down in order to maintain the proper flame. THE FLAME MAY NEED TO BE ADJUSTED DURING THE

TIME THE HEATER IS BEING OPERATED. Therefore, it is necessary to continue to monitor the flame , and to

make adjustments using the wick adjuster knob to keep the proper flame height. It is recommended that the heater

be checked every 30 minutes in order to keep the proper adjustment because periodic adjustment is required.

FAILURE TO KEEP THE WICK ADJUSTED PROPERLY WILL RESULT IN SMOKE, ODOR, IMPROPER

COMBUSTION, CARBON BUILD-UP, AND A SHORTER WICK LIFE.

NOTE : Occasionally during normal operation you will hear the sound of fuel draining from the cartridge tank to fill

the fuel reservoir area. This is normal for a cartridge tank kerosene heater.

WARNING

NEVER turn the wick adjuster knob lower than the "LOW" setting of the wick adjustment. If you

operate the heater below the position where the wick stop engages (the "LOW" setting), smoke, odor, excess

emissions, CO (carbon monoxide), and flare-ups can result.

BAD

Flame too low

●

Improper combustion

●

Produces oder

●

Reduces heat efficiency

●

EXTINGUISHING THE HEATER

To extinguish the heater, push the extinguish button. This should lower the wick to its lowest level. If the

wick is not completely lowered, continue to push the extinguish button and turn the wick adjuster knob in a

counterclockwise direction (towards "OFF") as far as it will go. After 2 or 3 minutes, lift up the burner

assembly using the burner knob and confirm that the heater has extinguished.(see Fig.9.)

GOOD

RED

Normal flame

●

perfect combustion

●

BLUE FLAME

RED

Fig.8

BAD

YELLOW FLAME

Flame too high

●

Improper combustion

●

Produces oder

●

Reduces heat efficiency

●

RED