Great Little Trading Hamilton L5131 Manuel - Sayfa 7

İç Mekan Mobilyaları Great Little Trading Hamilton L5131 için çevrimiçi göz atın veya pdf Manuel indirin. Great Little Trading Hamilton L5131 10 sayfaları.

Sayfayı Yazdır
STEP 7:
Take desk top panel G and position with all drill
holes facing up.
Insert the 2x drawer stops (#6) using 2x short
wood screws (#7). Use the smaller drill holes at
the straight front edge of the panel as shown.
Position them so that the curved end of the
drawer stop is facing to the notched back edge of
the panel.
Now insert 8x cam dowels (#1) into the selected
holes as shown below.
#1
BACK
#1
#1
#6
#1
Hardware for Step 7:
8x #1 Cam Dowels
2x #6 Drawer Stops
2x #7 Wood Screws (14mm)
#1
#1
#1
#7
G
#6
#1
FRONT
#7
#7
#6
STEP 8:
Carefully stand the partially build desk onto its feet.
Insert 6x wooden dowels (#4) partially built into the inner
holes on the top edges of leg panels D&E and central
divider panel C.
Now take desk top panel G and carefully lift it onto the
top of the desk frame. You may need the help of a second
person to do this. Orientate so the notches of the panel
fit around the back legs. Align all the cam dowels with their
corresponding holes in the frame and push firmly down.
When in place, insert 8x cam locks into the large drill
holes on the inside of the desk drawer space. There are 2
at the back (B), 2 on each side (D&E) and 2 on the central
diver panel (C). Turn all cam locks clockwise to secure in
place.
Then insert 2x barrel nuts (#3) into the holes on the back
of cross bar F. Insert 2x long bolts (#2) through the leg
panels and into the barrel nuts. Tighten Fully.
BACK
#4
#5
#3
#2
7
Hardware for Step 8:
2x #2 Bolts (67mm)
2x #3 Barrel Nuts
6x #4 Wooden Dowels
8x #5 Cam Locks
#4
#4
#5
#4
G
#5
#4
#5
#5
B
#5
C
#2
#4
#5
#3
F
D
#5
E