Great Little Trading Hamilton L5131 매뉴얼 - 페이지 7

{카테고리_이름} Great Little Trading Hamilton L5131에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Great Little Trading Hamilton L5131 10 페이지.

STEP 7:

Take desk top panel G and position with all drill

holes facing up.

Insert the 2x drawer stops (#6) using 2x short

wood screws (#7). Use the smaller drill holes at

the straight front edge of the panel as shown.

Position them so that the curved end of the

drawer stop is facing to the notched back edge of

the panel.

Now insert 8x cam dowels (#1) into the selected

holes as shown below.

BACK

Hardware for Step 7:

8x #1 Cam Dowels

2x #6 Drawer Stops

2x #7 Wood Screws (14mm)

FRONT

STEP 8:

Carefully stand the partially build desk onto its feet.

Insert 6x wooden dowels (#4) partially built into the inner

holes on the top edges of leg panels D&E and central

divider panel C.

Now take desk top panel G and carefully lift it onto the

top of the desk frame. You may need the help of a second

person to do this. Orientate so the notches of the panel

fit around the back legs. Align all the cam dowels with their

corresponding holes in the frame and push firmly down.

When in place, insert 8x cam locks into the large drill

holes on the inside of the desk drawer space. There are 2

at the back (B), 2 on each side (D&E) and 2 on the central

diver panel (C). Turn all cam locks clockwise to secure in

place.

Then insert 2x barrel nuts (#3) into the holes on the back

of cross bar F. Insert 2x long bolts (#2) through the leg

panels and into the barrel nuts. Tighten Fully.

BACK

Hardware for Step 8:

2x #2 Bolts (67mm)

2x #3 Barrel Nuts

6x #4 Wooden Dowels

8x #5 Cam Locks