Hi-Tech Diamond All-U-Need Kullanım Kılavuzu - Sayfa 9

Sander Hi-Tech Diamond All-U-Need için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Hi-Tech Diamond All-U-Need 16 sayfaları.

Grinding & Polishing Process

Step 5: Tech-10 Polish Pad w/ 14,000 Diamond Compound

The white Tech-10 Pad needs to be charged with the 14,000 Mesh

Diamond Compound. This is used for the final polish on your stone.

This pad is NOT to be used with water. Run it dry. The Diamond

Compound mixture contains its own carriers, making this unnecessary.

However, if you are working with Brittle heat sensitive material such

as opal, be careful not to let your work piece get too hot. Lower your

RPM and check your work piece frequently to avoid this. To charge

your polishing pad, take the syringe of 14,000 Mesh Diamond

Compound, remove the cap and squeeze a small amount onto your

Tech-10 Pad. Turn your machine on so that it spins slowly. Use your fingers to distribute the Diamond

Compound overwork area of the Tech-10 Pad. Once you have charged your Tech-10 Pad, turn your

machine on to working speed and apply work piece. Use only one type of polishing compound per

polishing pad.

Maintenance

Oiling: The only thing you ever oil on your All-U-Need machine is the inside of the 2" arbor. This is

necessary because the motor shaft and arbor are made of different materials. Over time, they can

seize together, making it impossible to remove the arbor. Every two months or so, remove the arbor by

sticking the hexagonal wrench into the set screw, turning counter-clockwise. Turn the arbor upside

down. Apply a few drops of motor oil or way oil in the area where it fits on the shaft, making sure there

is no excess oil. Make sure that no oil drips down the motor shaft. This will cause an instant motor

burn-out. A bit of lithium or water pump grease will serve as well. When putting the arbor back on the

shaft, be sure the screw is positioned against the flat side of the motor shaft. If the screw is positioned

against a rounded side of the shaft, it will make a squeaking noise and create friction, causing the

motor shaft to feel hot. Once the arbor is properly positioned, check the set screw for tightness on the

arbor, using the hexagonal wrench. Do not over tighten the screw, as you will need to remove it regu-

larly to clean the tray. The arbor may be adjusted up and down if necessary to keep the spinning disc

below the black spray shield.

Arbor

Set Screw

Cleaning: After every use, the All-U-Need is easily disassembled for cleaning. Rinse the black

splash guard and flush out white catch tray with CLEAN water. Any used water must NOT be disposed

down a sink as it can harden like cement, closing off the drain. Allow the machine to dry completely

then store it in a safe place, away from children.