GREAT PLANES Firebat Kullanım Kılavuzu - Sayfa 13

Oyuncak GREAT PLANES Firebat için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. GREAT PLANES Firebat 20 sayfaları.

Note: The motor is supplied with a flux ring installed. This

ring is present in the preceding photo and those that follow

and should be removed for the first flights. This ring will

increase flight time by reducing the current flow to the motor.

There is also a slight reduction in power.

❏

3. Fit the 1/16" [2mm] ply reinforcement plates to the rear

of the fuselage. The plates are slightly oversize so that they

may be fitted to a variety of motors. Trim the plates as

needed to fit the shape of the fuselage.

❏

4. Glue the reinforcement plates and the motor mount,

with the motor installed, into place with 6-minute epoxy.

The photo above shows the installation of a Kyosho AP-29

motor. As the motor is longer than the supplied motor, some

of the foam under the motor needs to be trimmed.

This photo shows the installation of a brushless motor and

speed control. Some trimming of the fuselage may be

needed, depending on the motor and speed controller.

Final Assembly

This photo used for the next two steps.

❏

1. Find one of the 1" [25.4mm] pieces that you cut from

the aileron pushrod and glue it to the groove in the rear

hatch. If you can't find one, a tooth pick can be used.