HiBoost F10G-5S-LCD Kullanıcı Kılavuzu - Sayfa 10

Genişletici HiBoost F10G-5S-LCD için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. HiBoost F10G-5S-LCD 18 sayfaları.

Quick Flashing Green

Quick Flashing Red

OFF

Measures: One of the actions below are recommended to eliminate ISO problems,

please note that these actions are the same for "Quick flashing green" , "Quick

Flashing red" and "OFF".

1. Adjust the antennas' pointing directions or locations or increase the distance

between them.

2. Increase the vertical or horizontal distance between the outdoor antenna and

indoor antenna.

3. Use barriers like walls to increase the isolation.

4. Change the indoor antenna type to an antenna with a more directional antenna

pattern. Orient the indoor antenna and outdoor antenna so they point in

opposite directions.

5. Reduce the booster's downlink gain using the manual gain controls. Keep the

uplink gain value and downlink gain value the same then restart the booster.

Note: Uplink gain must be equal to or not less than 5dB below the downlink gain,

to avoid interference with the local carrier's cell site network.

Target: The ISO issues are solved when the ISO LED is "Green" or "Slow Flashing

Green".

4.4 Manual Gain Control Operation

There are 4 operation modes relative to the control buttons: a long press for more

than 3 seconds on the "SET" button, short press on the "SET" button, short press on

"DEC-" button and short press on "INC+" button.

When the LCD is in the fixed display mode, press the "SET" key for 3 seconds and it

will start up in the Gain Setting Mode.

 Press the "SET" key shortly, and the LCD will switch to the next value (uplink

or downlink gain for a different band).

 Press the "INC+" (or "DEC-") key, and the value of the current gain item will

change to a higher (or lower) one.

 Press the "SET" key for 3 seconds, and the LCD will return to the fixed

display mode. (For more details refer to Manual Gain Control (MGC) below.

https://www.signalbooster.com/ | 1-855-846-2654 | [email protected]

Deep loop back or self-oscillation

Severe loop back or self- oscillation

The booster automatically shuts off

for protection due to very severe

self- oscillation.

Not working properly.

Check coverage. Leave it as is if it's

good. Actions must be taken if

coverage is not good.

Not working properly, actions must be

taken.