Automation Correct Coal-trol Digital TS2 V3 Kullanım Kılavuzu - Sayfa 14

Termostat Automation Correct Coal-trol Digital TS2 V3 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Automation Correct Coal-trol Digital TS2 V3 16 sayfaları.

Sayfayı Yazdır

Instruction Manual

Room Over-Temperature Cutout

DISPLAY

HiTemp

STOP

Maintenance and Troubleshooting

The Coal-trol Digital System is only the command and control piece of a properly operating stove. If the

Control Module power light is ON, and the Thermostat is displaying normally, the easiest way to

determine the source of an electrical or mechanical problem is to go to TEST mode and observe for

proper operation of the controlled item.

Problem

Power Light on Control

Module is not ON

Thermostat has no display.

Fire goes out now, but was

working before.

Hot coals falling off of grate.

Automation Correct LLC

Coal-trol Digital™ - Model TS2 V3

ACTION

The STATUS indicator light

blinks every second.

CAUTION: Before proceeding,

investigate the cause of the

over-temperature condition.

Press the MENU button to

Reset.

Possible Cause(s)

1) No power to Control Module.

2) Fuse blown in Control Module.

1) No power to Control Module.

2) Cable not snapped in.

3) Bad cable.

1) Stoker mechanism jamming or

dragging.

2) Hopper clogged or empty.

3) Stoker motor defective.

4) Combustion blower defective.

1) MAX set too high.

2) Control problem.

Check power.

Turn Power switch ON.

Replace fuse.

Bad Motor or bad wiring.

Bad Control Module.

Check power.

Snap in both ends of cable.

Replace cable.

Bad Thermostat.

Bad Control Module.

Go to TEST mode and verify that the

Stoker motor and Combustion blower

are working.

Troubleshoot mechanicals.

Verify fuel quality and sizing.

Bad control cable.

Bad Thermostat

Bad Control Module.

1) Go to TEST mode and verify that

the Stoker motor and Combustion

blower are working properly. If not,

replace Control Module.

2) Perform MAX/MIN adjustment.

5/2010 R0

Page 14

NOTE

The temperature sensor in

the thermostat has detected

a room temperature above

97°F/36°C and has disabled

all the controlled motors.

The HI TEMP display may

indicate a problem with your

stove, chimney, or Coal-trol

Digital System.

The thermostat will not allow

the MENU button to reset

the thermostat until the room

temperature is less than

96°F/35.5°C

Possible Solution(s)