ADEN POWERKIT GO Kullanım ve Montaj Kılavuzu - Sayfa 6

Bisiklet Aksesuarları ADEN POWERKIT GO için çevrimiçi göz atın veya pdf Kullanım ve Montaj Kılavuzu indirin. ADEN POWERKIT GO 16 sayfaları.

POWERKIT GO — ASSEMBLY INSTRUCTIONS

ADEN GmbH

ASSEMBLY

Needed tools:

» Allen key size 2,5

» Allen key size 3

» Allen key size 4

» Side cutter

» Cable tie

» Torque wrench 1-10Nm

» Belt

Ring ALIGNMENT-TOOL (optional)

Assembly

Clamp the bike in a work stand or turn it upside down. Remove

the rear wheel.

Depending on the number of spokes, the corresponding ring must

be used to be assembled.

36 spokes -> 9 clamps

32 spokes -> 8 clamps

28 spokes -> 7 clamps

Attention: The ring is always on the left side (brake disc)

assembled.

The belt ring is centered on the rear wheel and

each spoke is positioned between two holes.

First fix the spoke clamp to the spokes with the 2 outer screws

(Allen key size 2.5). Tighten the screws only slightly.

Fix all spoke clamps to the spokes.

Screw in the remaining screws a little so that the clamps can no

longer jump down.

The ring must still be easy to move on the wheel in order to

center it later.

www.aden-sports.com

(optional)

EN | P. 6