ADEN POWERKIT SPORT Kullanım ve Montaj Kılavuzu - Sayfa 10

Bisiklet ADEN POWERKIT SPORT için çevrimiçi göz atın veya pdf Kullanım ve Montaj Kılavuzu indirin. ADEN POWERKIT SPORT 16 sayfaları.

Sayfayı Yazdır
POWERKIT SPORT-ASSEMBLY INSTRUCTION
ADEN GmbH
ASSEMBLY
Use an Allen key size 4 to move the torque arm so that the
holding rod fits between them.
Then tighten the screws well (approx. 3Nm)
The fastening bolt is screwed into the torque arm with an Allen
key size 4. Don't forget the handrail!
Note:
Tighten the fastening bolt "hand-tight". (approx. 2 Nm)
The fastening bolt is "hollow" - if the tightening torque is too high,
it can break!
The display for the battery status is attached to the frame
with the Velcro tape supplied with the unit.
The cable is then laid along the frame with the Velcro cable
ties to the drive unit.
Red plug to red socket.
The thumb lever will be mounted in the desired location on the
handlebars with an Allen key size 3 and laid down along the
frame towards the bottom bracket/drive unit.
Make sure that a loop has to be laid for the steering angle as
with the other lines.
Yellow plug to yellow socket.
www.aden-sports.com
EN | S. 10