ADEN POWERKIT SPORT Kullanım ve Montaj Kılavuzu - Sayfa 9

Bisiklet ADEN POWERKIT SPORT için çevrimiçi göz atın veya pdf Kullanım ve Montaj Kılavuzu indirin. ADEN POWERKIT SPORT 16 sayfaları.

POWERKIT SPORT-ASSEMBLY INSTRUCTION

ADEN GmbH

ASSEMBLY

Wrong position !!!

So that the motor does not hang on the gear wheel as in the

picture, you can turn the drive unit by means of 3 screws.

First you remove the pinion guard with an Allen key size 3 and

then the pinion with an Allen key size 4.

With a TX20 screwdriver, you can remove the 3 screws.

Loosen half a turn and then turn the guide plate.

In the desired position, the screws should be tightened with

approx. 3 Nm.

The optimal position of the drive is as shown here in the picture.

To retrofit 26'' wheels, the motor should be turned completely

towards the swingarm, so that there is enough place to the rim.

Caution:

Turn the motor only so far that the "fan" does not

touch the upper guide pulley!

With 26 "wheels the fan of the motor may have to be dismantled

because the space between the rim and the motor is too little. To

do this, unscrew the 4 plastic screws and remove the fan from the

rotor.

Note: The fan only serves as "cooling support" and does not

necessarily have to be installed.

www.aden-sports.com

EN | S. 9