Galaxy DX 29HP Kullanıcı El Kitabı - Sayfa 3
Alıcı-Verici Galaxy DX 29HP için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Galaxy DX 29HP 8 sayfaları. 10 meter amateur mobile transceiver
Sayfayı Yazdır
RECEIVER
AM: 0.5 V for 10 dB (S+N)/N at greater than
Sensitivity
½ -watt of audio output.
FM: 1.0 V for 20 dB (S+N)/N at greater than
½-watt of audio output.
Selectivity
AM/FM: 6 dB @ 3 KHz, 50 dB @ 9 KHz.
Image Rejection
More than 65 dB.
IF Frequency
AM/FM: 10.695 MHz 1
IF
Adjacent-Channel
50 dB AM
Rejection
RF Gain Control
45
reception.
Automatic Gain Control
Less than 10 dB change in audio output for
(AGC)
inputs from 10 to 100,000mV.
Adjustable; threshold less than 0.5 V.
Squelch
ANL
Switchable
Noise Blanker
RF type
Audio Output Power
4 watts into 8 ohms.
Frequency Response
300 to 2500 Hz.
Built-in Speaker
8 ohms, round.
External Speaker (Not
8 ohms; disables internal speaker when
Supplied)
connected.
st
nd
IF, 455 KHz 2
dB
adjustable
for
optimum
-3-
Installation
LOCATION
Plan the location of the transceiver and microphone bracket before starting the
installation. Select a location that is convenient for operation and does not interfere
with the driver or passengers in the vehicles. In automobiles, the transceiver is
usually mounted below the dash panel, with the microphone bracket beside it.
MOUNTING THE RADIO
Your transceiver is supplied with a universal mounting bracket. When
mounting the bracket and radio to your car, make sure it is mechanically strong.
Also provide a good electrical connection to the chassis of the vehicle. Proceed as
signal
follows to mount the transceiver:
1. After you have determined the most convenient location in your vehicle, hold
the transceiver with mounting bracket in the exact location desired. If nothing
will interfere with mounting it in the desired position, remove the mounting
bolts. Before drilling the holes, make sure nothing will interfere with the
installation of the mounting bolts.
Connect the antenna coax connector to the standard antenna connector on the
2.
rear panel of the radio. Most antennas are terminated with a type PL-259
connector.
3. Connect the red DC power input wire (with the fuse) to +13.8V DC. This wire
extends from the rear panel. In automatic installation, +13.8V DC is usually
obtained from the accessory contact on the ignition switch. This prevents the
set being left on accidentally when the driver leaves the car and also permits
operating the unit without the engine running. Locate the accessory contact on
most ignition switches by tracing the power wire from the AM broadcast
receiver in the car.
4. Connect the black lead to –13.8V DC. This is usually the chassis of the car.
Any convenient location with good electrical contact (remove paint) may be
used.
5. Mount the microphone bracket on the right side of the transceiver or near the
transceiver, using two screws supplied. When mounting in an automobile,
place the bracket under the dash so the microphone is readily accessible.
- -
-4-