909 RC1200 Kullanım Kılavuzu - Sayfa 10

Testere 909 RC1200 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. 909 RC1200 12 sayfaları.

General cutting

1. Hold the saw firmly in front and

clearly away from you.

2. Make sure that the blade is

clear of any obstruction and

that the power cord or any

extension cord is out of the

path of the blade.

3. Ensure that the material to

be cut is held firmly. Small

workpieces should be held

in a vice or clamped to the

workbench.

4. Mark out the cutting line.

5. Squeeze the trigger.

6. Adjust the speed dial to correct

the speed for the material and

application..

7. Place the shoe on the workpiece and begin sawing.

Note.

Use only enough pressure to keep the saw cutting.

Do not force the cutting; allow the blade and the saw to do

the work.

WARNING.

Use of excessive pressure that causes bending

or twisting of the blade may cause the blade to break.

1. Mark the line of the cut.

2. Choose a point inside the area to be cut out and place

the tip of the blade over that point.

3. Rest the front edge of the shoe on the workpiece and

hold the saw firmly in position.

4. Press the lock-off button and squeeze the trigger to start

the cutting action.

WARNING.

Make sure that the blade does not touch the

workpiece until the blade has reached maximum speed

since this could cause loss of control and serious injury. Cut

slowly until the blade has fully penetrated the thickness of

the workpiece.