909 RC1200 Kullanım Kılavuzu - Sayfa 11

Testere 909 RC1200 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. 909 RC1200 12 sayfaları.

Metal cutting

Metals such as sheet steel, pipe,

steel rods, aluminium, brass and

copper can be cut with your saw.

Be careful not to bend or twist the

blade and do not force the cutting

action. We recommend that you

use cutting oil to lubricate the

cut when sawing soft metals and

steel. It keeps the blade cooler

and prolongs blade life.

CAUTION.

Clamp the work firmly and cut close to the

clamping point to minimise vibration. When cutting conduit

pipe or angle iron, clamp the work in a vice if possible and

cut close to the vice. To cut thin sheet metal, sandwich the

sheet between hardboard or plywood and clamp the layers

to prevent vibration and the tearing of the metal.

WARNING.

Always ensure that the tool is switched off and

the plug is removed from the power point before making any

adjustments or maintenance procedures.

Regularly check that all the fixing screws are tight.

They may vibrate loose over time.

1. Keep the tool's air vents unclogged and clean at all times.

2. Remove dust and dirt regularly. Cleaning is best done

with a rag.

3. Re-lubricate all moving parts at regular intervals.

4. Never use caustic agents to clean plastic parts.

CAUTION.

Do not use cleaning agents to clean the plastic

parts of the tool. A mild detergent on a damp cloth is

recommended. Water must never come into contact with

the tool.

If the supply cord needs replacing, the task must be carried

out by the manufacturer, the manufacturer's agent, or an

authorised service centre in order to avoid a safety hazard.