Adeneo Embedded i.MX53 Kullanıcı Kılavuzu - Sayfa 17

Anakart Adeneo Embedded i.MX53 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Adeneo Embedded i.MX53 20 sayfaları. Quick start board bsp for android gingerbread v4.2

Sayfayı Yazdır

U-Boot> setenv lvds 'setenv bootargs ${bootargs}

video=mxcdi0fb:RGB666,XGA ldb=di0 di0_primary'

U-Boot> setenv set_display 'run lvds'

U-Boot> save

● This will save the environment variables to the SD card. Restart the board and Android

will load.

Using USB peripherals on the QSB

USB camera

● Insert a UVC USB camera in the top USB host port. The camera should be automatically

detected.

● Run the Camera application from the Launcher.

Note: Only UVC cameras are supported for the QSB. If you need to use the CSI interface of the

i.MX53, please look at the SABRE Tablet files (referenced under the name i.MX53 SMD) for

more information.

USB mouse

● Insert a USB mouse camera in the top USB host port.

USB Keyboard

● Insert a USB keyboard in the top USB host port.

● The keyboard layout is defined in the sources, under src/device/fsl/imx5x/

Dell_Dell_USB_Keyboard*.

Please look at install/imx-android-r10.3/doc/i.MX_Android_R10.3_User_Guide.html for

more information.

Other USB peripherals

Other USB peripherals might require additional work and are not supported in this release.

Please contact Adeneo's support if you need more information.

Configuring your host for the adb

01/29/2012

Adeneo i.MX53 QSB BSP for Android Gingerbread 4.2

Page