909 20VHTG Kullanım Kılavuzu - Sayfa 10

Düzeltici 909 20VHTG için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. 909 20VHTG 16 sayfaları.

Sayfayı Yazdır

Unpacking

Due to modern mass production techniques, it is unlikely

that your 909 Power Tool is faulty or that a part is missing.

If you find anything wrong, do not operate the tool until the

parts have been replaced or the fault has been rectified.

Failure to do so could result in serious personal injury.

Assembly

Prior to carrying out any assembly work, adjustments or

maintenance, ensure the Battery pack has been removed

from the rear of the housing so operation of the trimmer is

impossible.

Important information – product care

This hedge trimmer uses Lithium-Ion battery cells. Care

MUST be taken to ensure both the safety and life of the

pack is maintained. Ensure you have read all of the safety

notes in the previous pages before using the hedge trimmer.

Safety devices and circuitry for this tool are located in

the battery pack of this tool. The battery pack is a vital

component, not just for the power source, but also for

the full safety control for both the charging and also the

tool operation. Treat the battery pack with care and within

the guidelines of this manual. If the pack does become

immersed in water or any fluids, or is subject to a severe

drop etc., or it does not operate within the guidelines of

this manual, immediately STOP using the battery pack

and have it checked.

During operation, avoid overloading the tool. If the tool is

overloaded it will automatically STOP. Overloading may

occur for a number of reasons including when the tool

is pushed too hard. If you do overload the tool during

operation refer to the "Overload" section in this manual.

Note:

When the battery of the tool is at the lower end of the

charge, the tool is more susceptible to the overload condition.

20VHTG IM ed6.indd 10

As mentioned above, the battery pack is an integral

component of this tool and is fitted with thermal safety

devices. Running the tool at close to maximum load, or

continual resetting of the overload will cause the battery

pack to over heat. When a preset cell temperature is

detected, the battery pack will automatically STOP

operating and will not restart until the battery pack has

cooled to a safe level.

In this condition, DO NOT force-cool the pack by placing in

a freezer or similar device. Refer to the "Overload" section

in this manual.

Another feature of the battery pack is the low voltage

cut out feature. This feature operates when the voltage

drops below a preset value. When this occurs the tool

will automatically stop operating. To correct the situation

you need to either insert another charged battery into the

trimmer or recharge the existing battery, and then proceed

with the application.

Note:

Attempting to restart the tool in this condition without

either recharging the battery or installing a battery with

charge will lead to it restarting and then stopping again after

only a few seconds of operation.

These safety devices have been fitted for the safety,

reliability and life of the tool.

28/8/13 8:10:01 AM