iHealth View Kullanıcı Kılavuzu - Sayfa 11

Kan Basıncı Monitörü iHealth View için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. iHealth View 12 sayfaları. Wireless blood pressure wrist monitor

Sayfayı Yazdır

BP7S is intended for use in the electromagnetic environment specified below. The user of BP7S should ensure that it is used in such an

environment.

IMMUNITY test

Conducted RF

3 Vrms 150 kHz to

IEC 61000-4-6

80 MHz

Radiated RF

3 V/m 80 MHz to 2.5

IEC 61000-4-3

GHz

NOTE 1 At 80 MHz and 800 MHz, the higher frequency range applies.

NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and reflection from

structures, objects and people.

a) Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and land mobile radios, amateur

radio, AM and FM radio broadcast and TV broadcast cannot be predicted theoretically with accuracy. To assess the electromagnetic

environment due to fixed RF transmitters, an electromagnetic site survey should be considered. If the measured field strength in the

location in which BP7S is used exceeds the applicable RF compliance level above, BP7S should be observed to verify normal operation. If

abnormal performance is observed, additional measures may be necessary, such as re-orienting or relocating BP7S.

b) Over the frequency range 150 kHz to 80 MHz, field strengths should be less than 3 V/m.

portable and mobile RF communications equipment and the Wireless Blood Pressure Wrist Monitor

BP7S is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled. The user of BP7S can help

prevent electromagnetic interference by maintaining a minimum distance between portable and mobile RF communications equipment

(transmitters) and BP7S as recommended below, according to the maximum output power of the communication equipment.

Rated maximum output

power of transmitter

For ME EQUIPMENT and ME SYSTEMS that are not LIFE-SUPPORTING

Guidance and manufacturer's declaration - electromagnetic immunity

Complian

IEC 60601test level

ce level

3 V

3 V/m

For ME EQUIPMENT and ME SYSTEMS that are not LIFE-SUPPORTING

Recommended separation distances between

Table 3

Electromagnetic environment - guidance

Portable and mobile RF communications equipment should be used no

closer to any part of BP7S, including cables, than the recommended

separation distance calculated from the equation applicable to the

frequency of the transmitter.

Recommended separation distance：

2 .

80 MHz to 800 MHz

3 .

800 MHz to 2.5 GHz

Where P is the maximum output power rating of the transmitter in watts (W)

according to the transmitter manufacturer and d is the recommended

separation distance in meters (m).

Field strengths from fixed RF transmitters, as determined by an

electromagnetic site survey,

each frequency range.

Interference may occur in the vicinity of equipment

marked with the following symbol:

Table 4

Separation distance according to frequency of transmitter

should be less than the compliance level in