DCA M1Q-FF-85 Çalıştırma Talimatları Kılavuzu - Sayfa 4
Elektrikli Alet DCA M1Q-FF-85 için çevrimiçi göz atın veya pdf Çalıştırma Talimatları Kılavuzu indirin. DCA M1Q-FF-85 10 sayfaları.
Sayfayı Yazdır
9.
Remove all obstacles both on and under the cutting line of the workpiece
during operation.
10. Check for the proper clearance beyond the workpiece before cutting so that
the blade will not strike the floor, workbench etc.
11. Do not cut oversize workpiece.
12. Rest the base flat on the workpiece in cutting operation, use stable supports
or workbench when cutting small and thin workpieces.
13. Do not leave the tool running. Operate the tool only when hand-held.
14. Always switch off and wait for the blade to come to a complete stop before
removing the blade from the workpiece.
15. Do not stop the blade by lateral pressure on it.
16. Do not touch the blade or the workpiece immediately after operation; they
may be extremely hot and could burn your skin.
17. In order to avoid operational malfunctions, do not saw gypsum board etc.
from below or overhead.
18. Do not work with materials containing asbestos.
19. Be sure to use an earth-leakage circuit breaker, with actuating current not
more than 30mA and actuating time not more than 0.1s, when use this tool
outside, and use only waterproof extension cords intended for outdoors use.
20. Never allow children or untrained person to use the tool.
SAVE THESE INSTRUCTIONS.
WARNING!
MISUSE or failure to follow the safety rules stated in this
instruction manual may cause serious personal injury.
-5-
GENERAL DESCRIPTION
1.
Screwdriver Inlet Hole
2.
Trigger Switch
3.
Lock Button
4.
Hex Wrench
5.
Switch for Sawdust Blower
6.
Base
7.
Blade Orbit Selector Lever
Note: *—Optional Accessory, Sold Separately; **—Commercially Available.
8.
Blade Roller Guide
9.
Saw Blade*
10.
Safety Protector
11.
Stroke Rod
12.
Scale for Bevel Cutting
13.
Hex Socket Head Screw
14.
Protractor**
-6-