DCA M1Q-FF-85 Çalıştırma Talimatları Kılavuzu - Sayfa 6

Elektrikli Alet DCA M1Q-FF-85 için çevrimiçi göz atın veya pdf Çalıştırma Talimatları Kılavuzu indirin. DCA M1Q-FF-85 10 sayfaları.

— Turn the saw blade with the teeth facing in the cutting

direction. Slightly lift the saw blade so that the back of the

saw blade comes to rest in the groove of the blade roller

guide. Allow it to engage by pulling slightly.

— Insert the provided screwdriver into

the screwdriver inlet hole and

tighten the locking screw clockwise

to finish the installment. (Fig. 5)

To remove the saw blade, follow the

installing procedure in reverse.

Sawdust Blower

The sawdust blower leads an air jet to the saw blade. The air jet keeps sawdust

from covering the cutting line during operation. The air flow can be switched on or

off with the switch for the sawdust blower.

Sawdust Blowing Level I:

Use low airstream when cutting in metals and when

coolants/ lubricants are used.

Sawdust Blowing Level II:

Use medium airstream when cutting in materials with low

chip removal rate, e. g. hardwood.

Sawdust Blowing Level III:

High airstream, for cuts in materials with high chip removal

rate, e.g. soft wood, plastic, etc.

-9-

Selecting Orbital Action

CAUTION:

Select the low orbital action setting (or switch it off) for a finer and cleaner cutting

edge.

Switch the orbital action off for cutting thin materials such as sheet metal.

Select the low orbital action when cutting hard materials such as steel.

Select high orbital action when cutting soft materials and when sawing in the

direction of the grain.

The four orbital action settings of the tool allow optimum adaptation of cutting speed,

cutting capacity and cutting pattern to the material being sawed. The orbital action can

be adjusted in four steps with the blade orbit selector lever, and it also can be adjusted

during operation.

Step 0:

No orbital action.

Step 1:

Low orbital action.

Step 2:

Medium orbital action.

Step 3:

High orbital action.

-10-