DCB XT-3305 Hızlı Başlangıç Kılavuzu - Sayfa 4

Ağ Donanımı DCB XT-3305 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. DCB XT-3305 4 sayfaları. Encrypted ethernet tunnel

11: Configure the Ethernet Tunnel section using these settings, shown in Figure 7 below:

Shared Secret = tom

Encryption = AES-256

Mode = client

Protocol = udp

(The Client Password is entered in the Client Mode Settings portion of the page when XT-3305

B is configured as a Client: The values in the Server Mode Settings fields are ignored in this

case.)

To make these changes active on XT-3305 B, click the Store&Activate button near the bottom

of the screen. Wait a few seconds to make sure the changes have been applied.

12: Connect an Ethernet cable between the untrusted ports (far left jack) of XT-3305 A and XT-

3305 B.

Testing the Link

If only one PC is available, it should be possible to connect to the LAN1 (trusted) network of

XT-3305 A and open a web browser window displaying the main menu of XT-3305 A and a

second browser window displaying the main menu of XT-3305 B. If the PC connection is moved

to the LAN1 (trusted) network of XT-3305 B, the same two menu pages should be accessible as

before. This verifies that the tunnel is configured properly and working.

In addition, if two PCs are available, allowing one to be on each side of the link, it should be

possible for each PC to ping the other over the link as if they were connected to the same switch.

Note that it is not possible to ping the LAN2 (Untrusted) interface from the LAN1 (Trusted)

interface: This is the way the tunnel is supposed to work.

Client Name = client1

Client Password = john

Remote Server IP = 192.168.2.1

Figure 7 – Ethernet Tunnel Settings for XT-3305 "B"