Autool C100 Kullanıcı Kılavuzu - Sayfa 3

Ultrasonik Mücevher Temizleyici Autool C100 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Autool C100 5 sayfaları. Fuel system cleaner

Without return hose connecting:

The hose line connection of theengine without returnhose is

shown as in Fig.02.

Disconnect the fuel supply hoses (E, F) of engine fuel system

(wrap the connector when disconnecting the connector), and

then choose a proper connector and connect it to the E end.

Reconnect the fuel outlet hose of the unit well and make the

fuel return hose hanging. See Fig.02.

Stop the other end of the disconnected end (F) with a proper

stopper, (use when the fuel pump has the fuel return function

only) or remove the fuse of fuel pump or disconnect the power

cable of fuel pump.

Fig.02

1-C100 Cleaner & Tester; 2-Engine; 3-stopper; 4- Fuel-inlet hose

to engine; 5-Auto tank; 6-Auto filter; 7- Engine fuel supply hose;

8-Auto fuel pump;

The pictures

Pour the mixture of gasoline and detergent into steel bottle of

the C100.

Close the valve of C100's fuel-outlet pipe and open the valve

of C100's air-inlet port and then connect to the compress air.

Adjust the pressure of air within 0.3 to 0.4MPa（ 3 to

4kgf/cm2） by air control valve.

Connect the fuel supply adaptor of C100 to fuel supply pipe of

the car fuel system, and open the ball valve. Check if it has

some leaking between all the connections. There must have

no any leaking when doing the cleaning work.

Start engine to start flushing the fuel system.

Drain out the pressure in the C100's bottle after flushing, and

then disconnect the C100.

Restore all of the pipes of the fuel system and check there

have no leaking.

Note: The connection ways for carburetor fuel system is

same to electronic fuel injection system. The pressure in

carburetor fuel system must be 0.07~0.35 kgf/cm2.