Autoplugin Key-V3 Kullanıcı Kılavuzu - Sayfa 4

Kontrol Ünitesi Autoplugin Key-V3 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Autoplugin Key-V3 8 sayfaları.

Basic Functions

1. A special combination of buttons presses is used to start the heater from a

remote control key. Firstly press "Lamp" button on the key to switch on car

lighting. Then press "Lock" button twice within 30 seconds, while lighting

is on. Every "Lock" button pressing is confirmed with direction indicators

flashing.

2. To stop the heater with a remote control key, switch on and then switch off

car lighting twice. Intervals between "Lamp" button presses should not

exceed 20 seconds.

3. It is possible remotely disable heater timers, programmed in the CIP. Use

remote control key to send stop command when the heater is idle. Starting

the heater any way or turning ignition to "on" position enables CIP timers

again.

By default the module adjusted to perform only basic functions, such as start

and stop of the heater by using remote control key. To switch on additional

functions such as flashing with direction indicators in rearview mirrors, etc. enter

the module into Setup mode and activate corresponding setup item (see settings

table 1).

The buttons of the left-hand stalk switch and the brakes pedal are used to

enter Setup mode and to change the settings. It is necessary to stop the engine and

the heater before. Switch the ignition on (turn the key to the position II), then press

and hold the brakes pedal. Rotate the thumbwheel some steps to select blank

display in the CIP. Then press and hold for at least 5 seconds "Read" button ("OK"

button in some cars), while module's LED flashes once a second. Both direction

indicators in the CIP confirm entering setup mode with 2 flashes. Release the

brakes pedal and "Read/OK" button finally.

Each setup item in the settings table is a 3-digit code. To enter a digit of a

code, shortly press "RESET" button so much times, as corresponds to a digit. The

LED and the direction indicators symbols in the CIP confirm each button press: the

LED briefly goes off, the left direction indicator flashes one time when the first or

the third digit of code is entered, the right direction indicator - when the second

digit of code is entered. To complete a digit entering, press and release "Read/OK"

button. The CIP confirms it with one flash of both direction indicators

simultaneously. When all three digits are entered, the module checks the code for

validity and confirms it with direction indicators flashing. Both direction indicators

flash twice simultaneously in case of valid code and flash twice alternately in case

of invalid code.