Dynatech V-5000 Kullanıcı Talimatları - Sayfa 7

Amplifikatör Dynatech V-5000 için çevrimiçi göz atın veya pdf Kullanıcı Talimatları indirin. Dynatech V-5000 16 sayfaları. Professional

Set Up

INPUTS- The V-5000/V-7000 amplifier allows you to use two types of input connector per channel, a XLR jack for balanced

connections and a 1/4" female jack that will accept balanced and unbalanced connectors. Use these connections to connect

the output signal from a mixer, cross-over or EQ to your V-5000/V-7000 amplifier. A balanced connection is recommended for

cable runs longer that 20ft. When constructing your own XLR cables follow the pin configuration describe below for proper

connections. For cable runs shorter than 20ft. you may choose the 1/4" unbalanced input option. The 1/4" unbalanced input

option may be more convenient for most users due to the abundant supply of prefabricated cables available at your local

audio dealer. You may use the two XLR "Input Thru" jacks to jump a parallel connection to another amplifier or other device.

For Example: Connect a XLR cable to the input of channel one. You may now connect a XLR cable from the channel one "Input

-Thru" jack to the input jack of another amplifier's channel one input. This will reduce the use of "Y" cables.

M a le X LR Pin Conf gura t ion:

US ITT Standard

2.Hot(+data)

3.Negative (- data)

Binding Post/Banana Plug - Connect your speakers to the binding post outputs on the rear of the amplifier. The

speaker wire may be connect by bare wire (directly connected, usually for permanent connections), banana plug,

or spade connector. Connections are made to Channels 1 and 2 output's for stereo mode or across the red termi-

nals of Channels 1 and 2 for Mono Bridge Mode.

Important Notice: Although a speaker will operate with the positive and negative leads plugged into either termi-

nal on the amplifier binding post, be sure to plug the negative lead into the black terminal and positive lead into

the red terminal. Ensuring proper polarity will avoid speakers being out of phase, that can cause a loss of bass

response.

Important Notice: Banana Plugs - When connecting your speakers to the amplifier using banana jacks; Be sure that the red and black

caps on the binding post are completely screwed in. Insert the banana jacks into the caps of the binding post, be sure that the banana

jack is inserted securely to avoid the risk of it popping out.

Diagram 3

1. Ground/Return/0v)

Ba la nc e d T RS 1 /4 " Plug

Diagram 4

Hot (+)

Ground/Shield

Negative (-)

page 7

U nba la nc e d T S 1 /4 " Plug

Diagram 5

Hot (+)

Negative (-)

Diagram 6